An Easy Way to Paint Plantation Shutters

Give these old stores a little color

You know there's an easier way to paint plantation shutters. If your window coverings have lost their color over the years, you do not have to spend tons of money to replace them, but just repaint. This will not only give your old blinds a little color and shine, but also to update the look of your home. This applies in particular to certain shades of neutral colors like white or cream color tends to get dirty over time or damaged. Well, this is the perfect opportunity to start planting component of the project repainted.

Try to plan each step before starting the project. This will avoid problems later, because once you start painting, it will be too late to go back. This includes all the things you need and determine where you are going to paint the shutters. Also, since you will end up with blinds, make sure remember (or write) what you did, because that way you will not have problem to put the blinds back up. Just follow these steps and you will have a window treatment freshly painted shortly.

Shutters Painting steps

As previously mentioned, the first thing you have to do is separate the blinds. It is important to properly mark each panel to return to the correct position once the painting is done. This also applies to the hinges and other hardware, and the differences can cause alignment problems. Once you have removed the shutters on the windows, it would be prudent to remove all the hardware, such as hinges, hooks or buttons attached to the panels. There is a screwdriver and a few minutes, but it will save all the time trying to conceal or hide the other, or worse, try to remove the paint somehow ended up there. Also, take this opportunity to check whether the equipment should be repaired or replaced.

The next step is the right way to clean the panels. Make sure that the goods, as any dirt or debris trapped on the surface will not only make it harder for the paint to stick, but it can also affect the smoothness of the surface of the shutter look freshly painted. This can be done using nothing more than a little mild detergent and a little hot water. Finally, do not begin to paint until the surface is completely dry.

The next thing you have to do is scrape the blinds with a little metal paint scraper and sandpaper. This way you will have a smooth surface to paint much easier. However, not exceed scratching, not to damage the panels as anyway.

Before applying the paint to the shutters would be great to use a water-based primer. Cover the entire surface with a thin layer of primer paint will adhere much easier, regardless of the paint has been used previously.

When it comes to the art of painting, you can use a brush or a little spray paint. Although it may seem fun with a brush, it usually takes a long time (depending on the size of the brush and the size of the blinds), but can also cause potential problems to operate the shutter mechanism. Ie, there is the possibility that the paint will get into the spaces between the fins and the frame (no matter how careful) which, when dried subsequently affect the fluidity of the opening or closing shutters.

Once you have determined how you are going to paint plantation shutters, prepare the workplace. You can hang the panels that allow you to paint both sides at the same time or place them on the floor, covered front newspaper or old cloth, which means you have to paint a face and once it is sec, and the turn panel on the other hand painting.

Finally, you can start blinds paint job. If you selected a brush, use flat brushes to apply the paint more evenly. Paint on smooth, even strikes. If you choose to use spray paint, just shake the bottle before you begin to apply the paint and vertically rather than horizontally. Keep about 30 inches of tin and spray the soft color without sudden movements that can cause stains and the difference in shades of color panels. A coat of paint should do the trick, but if you want a more intense, you can add another layer.

At the end of the painting process blinds, make sure the paint is completely dry, replace the blinds. If you have already marked its original position and all screws are kept in one place, this should not be a difficult task. Take a step back and admire your work.